ROVER 75 (RJ) 2.5 V6
Choose your car manufacturer, model and engine type. This will allow our system to find parts for your vehicle.
ROVER 75 (RJ) 2.5 V6
Choose a car by KBA.
ROVER 75 (RJ) 2.5 V6
Choose an engine.
Spare parts ROVER 75 (RJ) 2.5 V6
Operating Mode: | Hydraulic |
Fitting Position: | Intake Side |
Fitting Position: | Exhaust Side |
Fitting Position: | for cylinder 1-6 |
Warehouse: | > 25 pcs | |
Warehouse 2 (+3 days): | > 25 pcs |
Inner Diameter [mm]: | 32 mm |
Outer Diameter [mm]: | 45 mm |
Height [mm]: | 8 mm |
Warehouse: | 1 pcs |
Oxygen Sensor: | Regulating Probe |
Oxygen Sensor: | Heated |
Voltage [V]: | 12 V |
Conductor Number: | 1 conductor |
Cable Length [mm]: | 650 mm |
Inner Diameter [mm]: | 30 mm |
Outer Diameter [mm]: | 40 mm |
Height [mm]: | 7 mm |
Radial Shaft Seal Design: | ASW |
Swirl Type: | Left-hand Twist |
Material: | FPM (fluoride rubber) |
Dust Cover: | with dust lip |
Warehouse: | 0 pcs | |
Supplier: | Check |
Length [mm]: | 550 mm |
Length [mm]: | 550 mm |
Supplementary Article/Info 2: | with vehicle-specific adaptor |
Matching Adapter: | V12 |
Length [mm]: | 550 mm |
Supplementary Article/Info 2: | with vehicle-specific adaptor |
Electrode Gap [mm]: | 1,0 mm |
Tightening Torque [Nm]: | 28 Nm |
Thread Size: | M 14 x 1,25 |
Thread Length [mm]: | 19 mm |
Spanner Size: | 16 |
Spark Position [mm]: | 4 mm |
Number of pins: | 1 -pin connector |
Electrode Gap [mm]: | 0,7 mm |
Tightening Torque [Nm]: | 28 Nm |
Thread Size: | M 14 x 1,25 |
Thread Length [mm]: | 19 mm |
Spanner Size: | 16 |
Spark Position [mm]: | 4 mm |
Number of pins: | 1 -pin connector |
Filter type: | Spin-on Filter |
Height [mm]: | 124 mm |
Thread Size: | 13/16" 16 UN |
Outer Diameter [mm]: | 76 mm |
Gasket outside diameter [mm]: | 72 mm |
Gasket inside diameter [mm]: | 62 mm |