Search by vehicle
Search by KBA
Search by engine
Choose your car manufacturer, model and engine type. This will allow our system to find parts for your vehicle.
Choose a car by KBA.
Choose an engine.
View search
Hide search
Items for cross-reference number 1112901700
General information
Code: | BMO-VW-012 |
Brand: | NTY |
Title: | Oil Sump |
Car: | VW GOLF IV/V 1.4 16V, 1.6 16V 97-06, POLO 1.4 16V 02-09, SKODA FABIA 1.4 16V 99-08, OCTAVIA 1.4 16V 00-10, SEAT CORDOBA/IBIZA 1.4 16V 02-09 /WITH HOLE FOR OIL SENSOR/ |
Weight : | 2,32 kg |
Criteria
Supplementary Article/Info 2: | with bore for oil-level sensor |
Fabrication Number: | BMO-VW-012 |
General information
Code: | V10-0449 |
Brand: | VAICO |
Title: | Oil Sump |
Car: | VW |
Weight : | 0,00 kg |
Criteria
Section: | Lower Section |
Oil Sump Material: | Aluminium |
Supplementary Article/Info 2: | with bore for oil-level sensor |
See accessories list for additionally required parts: | yes |
Width [mm]: | 235,0 mm |
Fitting Position: | Oil Sump |
Height [mm]: | 155 mm |
Supplementary Article/Supplementary Info: | with oil drain plug |
Observe the vehicle manufacturer specifications: | yes |
Observe system fill quantity: | yes |
Length [mm]: | 420 mm |
Supplementary Article/Info 2: | with seal ring |
Supplementary Article/Info 2: | without oil sump gasket |
Weight [kg]: | 2,422 kg |
General Information: | Products supplied by us are without exception intended for the designated use. Please note that our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist personnel. There is no guarantee for inappropriate, improper or unintended use. |
General Information: | In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events. |
Show all
Show less